Nissan Altima 2007-2012 Service Manual: CVT position

Inspection and Adjustment

INSPECTION

1. Place selector lever in “P” position, and turn ignition switch ON (engine stop).

2. Make sure that selector lever can be shifted to other than “P” position when brake pedal is depressed.

Also make sure that selector lever can be shifted from “P” position only when brake pedal is depressed.

3. Move the selector lever and check for excessive effort, sticking, noise or rattle.

4. Confirm the selector lever stops at each position with the feel of engagement when it is moved through all the positions. Check that the actual position of the selector lever matches the position shown by the shift position indicator and the manual lever on the transaxle.

5. The method of operating the selector lever to individual positions correctly should be as shown.

6. When selector button is pressed in “P”, “R”, or “N” position without applying forward/backward force to selector lever, check button operation for sticking.

7. Confirm the back-up lamps illuminate only when selector lever is placed in the “R” position. Confirm the back-up lamps do not illuminate when the selector lever is pushed toward the “R” position when in the “P” or “N” position.

8. Confirm the engine can only be started with the selector lever in the “P” and “N” positions.

9. Make sure transaxle is locked completely in “P” position.

10. When selector lever is set to manual shift gate, make sure that manual mode is displayed on combination meter.

Shift selector lever to “+” and “-” sides, and check that set shift position changes.

ADJUSTMENT

CAUTION: Apply parking brake before adjustment. 1. Loosen the control cable nut.

2. Place the manual lever and the selector lever in “P” position.

3. Tighten control cable nut to specified torque.

Control cable nut: Refer to TM-433, "Exploded View".

CAUTION: Secure the manual lever when tightening control cable nut. Make sure the manual lever stays in the "P" position.

4. Check the operation of the CVT.

    Road test
    Description DESCRIPTION • The purpose of the test is to determine overall performance of CVT and analyze causes of problems. • The road test consists of the following three parts: 1. “Che ...

    Other materials:

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the dr ...

    TCM branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). - TCM - Harnes ...

    Engine control system
    System Diagram System Description ECM performs various controls such as fuel injection control and ignition timing control. Component Parts Location 1. Power valve actuator 1 2. Intake valve timing control solenoid valve (bank 1) 3. Power steering pressure sensor 4. Intake valve timi ...