Nissan Altima Owners Manual: Difference between predicted and actual distances

The distance guide line and the vehicle width guide line should be used as a reference only when the vehicle is on a level, paved surface. The distance viewed on the monitor is for reference only and may be different than the actual distance between the vehicle and displayed objects.

Backing up behind a projecting object


Backing up behind a projecting object

The position C is shown farther than the position B in the display. However, the position C is actually at the same distance as the position A .

The vehicle may hit the object when backing up to the position A if the object projects over the actual backing up course.

Backing up on a steep downhill


Backing up on a steep downhill

When backing up the vehicle down a hill, the distance guide lines and the vehicle width guide lines are shown farther than the actual distance.

For example, the display shows 3 ft (1.0 m) to the place A , but the actual 3 ft (1.0 m) distance on the hill is the place B . Note that any object on the hill is closer than it appears on the monitor.

    How to read the displayed lines
    Guiding lines which indicate the vehicle width and distances to objects with reference to the vehicle bumper line A are displayed on the monitor. Distance guide lines: Indicate distances from ...

    How to adjust the screen (if so equipped)
    settings, press the SETTING button while the RearView Monitor screen is displayed. Each time the SETTING button is pressed, the next setting item is selected. Turn the TUNE·SCROLL/TUNE·FOLDER co ...

    Other materials:

    B2560 starter control relay
    Description Starter control relay, integrated in IPDM E/R, permits the starter relay operation when in N or P position and the steering is locked or unlocked. It is installed in parallel with the starter relay. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2560 is displayed with DTC U1 ...

    Exhaust manifold and three way catalyst
    Removal and Installation 1. Exhaust manifold heat shield (RH) 2. Air fuel ratio (A/F) sensor 1 (bank 1) 3. Exhaust manifold (RH) 4. Gaskets 5. Heated oxygen sensor 2 (bank 1) 6. Three way catalyst (manifold) (bank 1) 7. Three way catalyst (manifold) (bank 2) 8. Heated oxygen sensor 2 (ba ...

    P0550 PSP Sensor
    Description Power steering pressure (PSP) sensor is installed to the power steering high-pressure tube and detects a power steering load. This sensor is a potentiometer which transforms the power steering load into output voltage, and emits the voltage signal to the ECM. The ECM controls t ...