Nissan Altima 2007-2012 Service Manual: Does not operate by key cylinder switch
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-190, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement".
Is the inspection result normal? YES >> GO TO 2
NO >> Repair or replace the malfunctioning parts.
2. CHECK DOOR LOCK ASSEMBLY LH (KEY CYLINDER SWITCH)
Check door lock assembly LH (key cylinder switch).
Refer to PWC-214, "Component Function Check".
Is the inspection result normal? YES >> Inspection End.
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Power window retained power operation
does not operate properly
Diagnosis Procedure
1. CHECK DOOR SWITCH
Check door switch.
Refer to PWC-212, "Component Function Check".
Is the inspection result normal?
YES >> Inspection End.
NO >&g ...
Keyless power window down does
not operate
Diagnosis Procedure
1. CHECK INTELLIGENT KEY FUNCTION
Check Intelligent Key function.
Refer to SEC-16, "System Description".
Is the inspection result normal?
YES >> Check inte ...
Other materials:
TCM branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose
connection (unit side and connector
side).
- TCM
- Harnes ...
ASCD indicator
Description
The ASCD operation status is indicated by two indicators, (CRUISE and SET on
the information display) on
the combination meter.
CRUISE indicator is displayed to indicate that ASCD system is ready for
operation when MAIN switch on
ASCD steering switch is turned ON.
SET indica ...
P0011 IVT Control
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P0011 is displayed with DTC P0075, first perform the trouble diagnosis
for EC-867, "DTC Logic".
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn
ignition switch OFF ...