Nissan Altima (L32) 2007-2012 Service Manual: Does not operate by key cylinder
switch
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special
Repair Requirement".
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace the malfunctioning parts.
2. CHECK FRONT DOOR LOCK ASSEMBLY LH (KEY CYLINDER SWITCH)
Check front door lock assembly LH (key cylinder switch).
Refer to PWC-328, "Component Function Check".
Is the inspection result normal?
YES >> Inspection end.
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Diagnosis Procedure
1. CHECK FRONT DOOR SWITCH
Check front door switch.
Refer to PWC-326, "Component Function Check".
Is the inspection result normal?
YES >> Inspection end.
...
Diagnosis Procedure
1. CHECK INTELLIGENT KEY FUNCTION
Check Intelligent Key function.
Refer to DLK-340, "Component Function Check".
Is the inspection result normal?
YES >> Ch ...
Other materials: Rear Cross Traffic Alert (RCTA)
WARNING
Failure to follow the warnings and instructions
for proper use of the RCTA
could result in serious injury or death.
The RCTA system is not a replacement
for proper driving procedures
and is not designed to prevent contact
with vehicles or objects. When
backing out of a parking space, a ...
Intelligent Driver Alertness (I-DA)
system limitations
WARNING
Listed below are the system limitations
for the I-DA system. Failure to operate
the vehicle in accordance with these
system limitations could result in serious
injury or death.
The I-DA system may not operate
properly and may not provide an
alert in the following conditions:
Poor road ...
Programming HomeLink
If you have any questions or are having
difficulty programming your HomeLink
buttons, refer to the HomeLink website at:
www.homelink.com or call 1-800-355-3515.
NOTE:
Place the ignition switch in the ON position
(without starting the engine) when
programming HomeLink. It is also recommended that
ane ...
Power window retained power operation
does not operate properly
Keyless power window down does
not operate