Nissan Altima 2007-2012 Service Manual: Front passenger side power window alone does not operate

Diagnosis Procedure

1. CHECK POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH

Check power window and door lock/unlock switch RH.

Refer to PWC-308, "FRONT POWER WINDOW SWITCH : Component Function Check".

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace the malfunctioning parts.

2. CHECK POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH SERIAL LINK CIRCUIT

Check power window and door lock/unlock switch RH serial link circuit.

Refer to PWC-332, "FRONT POWER WINDOW SWITCH : Component Function Check".

Is the inspection result normal? YES >> GO TO 3

NO >> Repair or replace the malfunctioning parts.

3. CHECK FRONT POWER WINDOW MOTOR RH CIRCUIT

Check front power window motor RH circuit.

Refer to PWC-315, "PASSENGER SIDE : Component Function Check".

Is the inspection result normal? YES >> Inspection end.

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Driver side power window alone does not operate
    Diagnosis Procedure 1. CHECK FRONT POWER WINDOW MOTOR LH Check front power window motor LH. Refer to PWC-313, "DRIVER SIDE : Component Function Check". Is the inspection result norm ...

    Rear lh side power window alone does not operate
    Diagnosis Procedure 1. CHECK REAR POWER WINDOW SWITCH LH Check rear power window switch LH. Refer to PWC-310, "REAR POWER WINDOW SWITCH : Component Function Check". Is th e inspectio ...

    Other materials:

    Intake manifold collector
    Removal and Installation 1. Power valve (RH) 2. Intake manifold collector 3. Gasket 4. Power valve (LH) 5. Electric throttle control actuator REMOVAL WARNING: • To avoid the danger of being scalded, never drain the coolant when the engine is hot. • The gasket for intake manifold c ...

    STRG branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the steering angle sensor for damage, bend and loose connection (unit side and connector side). ...

    Rear speaker
    Removal and Installation - Coupe REMOVAL 1. Remove the trunk front finisher. Refer to INT-23, "Removal and Installation". 2. Remove the rear speaker screws (A), then disconnect the rear speaker connector (B) and remove the rear speaker (1). INSTALLATION Installation is in the ...