Nissan Altima 2007-2012 Service Manual: Rear lh side power window alone does not operate

Diagnosis Procedure

1. CHECK REAR POWER WINDOW SWITCH LH

Check rear power window switch LH.

Refer to PWC-310, "REAR POWER WINDOW SWITCH : Component Function Check".

Is th e inspection result normal? YES >> GO TO 2

Check rear power window switch LH.

Refer to PWC-310, "REAR POWER WINDOW SWITCH : Component Function Check".

Is th e inspection result normal? YES >> GO TO 2

2. CHECK REAR POWER WINDOW MOTOR LH

Check rear power window motor LH.

Refer to PWC-316, "REAR LH : Component Function Check".

Is th e inspection result normal? YES >> Inspection end.

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Front passenger side power window alone does not operate
    Diagnosis Procedure 1. CHECK POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH Check power window and door lock/unlock switch RH. Refer to PWC-308, "FRONT POWER WINDOW SWITCH : Component Function ...

    Rear rh side power window alone does not operate
    Diagnosis Procedure 1. CHECK REAR POWER WINDOW SWITCH RH Check rear power winodw switch RH. Refer to PWC-310, "REAR POWER WINDOW SWITCH : Component Function Check". Is the inspectio ...

    Other materials:

    Front fog lamp
    System Diagram System Description • BCM (Body Control Module) controls front fog lamp operation. • IPDM E/R (Intelligent Power Distribution Module Engine Room) operates front fog lamp according to CAN communication signals from BCM. • Combination meter operates front fog lamp indi ...

    Evaporative emission system
    System Diagram System Description INPUT/OUTPUT SIGNAL CHART *1: ECM determines the start signal status by the signals of engine speed and battery voltage. *2: This signal is sent to the ECM via the CAN communication line. SYSTEM DESCRIPTION The evaporative emission system is used to ...

    Squeak and rattle trouble diagnoses
    Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs.Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any customer's comments; refer to RF-86, "Diag ...