Nissan Altima 2007-2012 Service Manual: Front wiper motor hi circuit

Component Function Check

1. CHECK FRONT WIPER HI OPERATION

1. Start IPDM E/R auto active test. Refer to PCS-14, "Diagnosis Description".

2. Check that the front wiper operates at the HI operation.

1. Select "FRONT WIPER" of IPDM E/R active test item.

2. While operating the test item, check that front wiper HI operation and OFF.

Does the front wiper operate? YES >> The front wiper motor HI circuit is normal.

NO >> Refer to WW-20, "Diagnosis Procedure".

Diagnosis Procedure

1. CHECK FRONT WIPER MOTOR (HI) OUTPUT VOLTAGE

1. Turn the ignition switch OFF.

2. Disconnect front wiper motor.

3. Turn the ignition switch ON.

4. Select "FRONT WIPER" of IPDM E/R active test item.

5. With operating the test item, check voltage between IPDM E/R harness connector and ground.

Is the measurement normal? YES >> GO TO 2

NO >> Replace IPDM E/R. Refer to PCS-48, "Removal and Installation".

2. CHECK FRONT WIPER MOTOR (HI) OPEN CIRCUIT

1. Turn the ignition switch OFF.

2. Disconnect IPDM E/R.

3. Check continuity between IPDM E/R harness connector (A) and front wiper motor harness connector (B).

Does continuity exist? YES >> GO TO 3

NO >> Repair or replace harness.

3. CHECK FRONT WIPER MOTOR (HI) SHORT CIRCUIT

Check continuity between IPDM E/R harness connector and ground.

Does continuity exist? YES >> Repair or replace harness.

NO >> Replace front wiper motor. Refer to WW-116, "FRONT WIPER DRIVE ASSEMBLY : Removal and Installation".

    Front wiper motor lo circuit
    Component Function Check 1. CHECK FRONT WIPER LO OPERATION 1. Start IPDM E/R auto active test. Refer to PCS-14, "Diagnosis Description". 2. Check that the front wiper operates at the ...

    Front wiper auto stop signal circuit
    Component Function Check 1. CHECK FRONT WIPER (AUTO STOP) OPERATION 1. Select "FRONT WIPER STOP" of IPDM E/R DATA MONITOR item. 2. Operate the front wiper. 3. With the front wiper ...

    Other materials:

    BCM branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the BCM for damage, bend and loose connection (unit side and connector side). Is the inspec ...

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the dr ...

    On-vehicle repair
    BATTERY Removal and Installation REMOVAL 1. Remove air duct (front). Refer to EM-25, "Removal and Installation" QR25DE models, EM-129, "Removal and Installation" VQ35DE models. 2. Loosen battery terminal nuts, and disconnect both battery terminals. CAUTION: When disc ...