Nissan Altima 2007-2012 Service Manual: Front wiper motor lo circuit

Component Function Check

1. CHECK FRONT WIPER LO OPERATION

1. Start IPDM E/R auto active test. Refer to PCS-14, "Diagnosis Description".

2. Check that the front wiper operates at the LO operation.

1. Select "FRONT WIPER" of IPDM E/R active test item.

2. While operating the test item, check that front wiper LO operation and OFF.

Does the front wiper operate? YES >> Front wiper motor LO circuit is normal.

NO >> Refer to WW-20, "Diagnosis Procedure".

Diagnosis Procedure

1. CHECK FRONT WIPER MOTOR (LO) OUTPUT VOLTAGE

1. Turn the ignition switch OFF.

2. Disconnect front wiper motor.

3. Turn the ignition switch ON.

4. Select "FRONT WIPER" of IPDM E/R active test item.

5. With operating the test item, check voltage between IPDM E/R harness connector and ground.

Is the measurement normal? YES >> GO TO 2

NO >> Replace IPDM E/R. Refer to PCS-48, "Removal and Installation".

2. CHECK FRONT WIPER MOTOR (LO) OPEN CIRCUIT

1. Turn the ignition switch OFF.

2. Disconnect IPDM E/R.

3. Check continuity between IPDM E/R harness connector (A) and front wiper motor harness connector (B).

Does continuity exist? YES >> GO TO 3

NO >> Repair or replace harness.

3. CHECK FRONT WIPER MOTOR (LO) SHORT CIRCUIT

Check continuity between IPDM E/R harness connector and ground.

Does continuity exist? YES >> Repair or replace harness.

NO >> Replace front wiper motor. Refer to WW-116, "FRONT WIPER DRIVE ASSEMBLY : Removal and Installation".

    Wiper and washer fuse
    Description Diagnosis Procedure 1. CHECK FUSES Check that the following fuses are not blown. Is the fuse blown? YES >> Replace the blown fuse after repairing the affected circuit. NO ...

    Front wiper motor hi circuit
    Component Function Check 1. CHECK FRONT WIPER HI OPERATION 1. Start IPDM E/R auto active test. Refer to PCS-14, "Diagnosis Description". 2. Check that the front wiper operates at the ...

    Other materials:

    P0605 ECM
    Description The ECM consists of a microcomputer and connectors for signal input and output and for power supply. The ECM controls the engine. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always tur ...

    Locking with key
    Driver’s side Manual (if so equipped) To lock a door, turn the key toward the front of the vehicle 1 . To unlock, turn the key toward the rear of the vehicle 2 . Power (if so equipped) The power door lock system allows you to lock or unlock all doors at the same time. Turning the key ...

    B210c starter control relay
    Description Starter control relay, integrated in IPDM E/R, permits the starter relay operation when in N or P position and the steering is locked or unlocked. It is installed in parallel with the starter relay. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B210C is displayed with DTC U100 ...