Nissan Altima (L32) 2007-2012 Service Manual: Hazard warning lamps flash
Hazard Warning Lamps Flash When Ignition
Switch Is Turned On
DIAGNOSTIC PROCEDURE
1.CHECK BCM GROUND CIRCUIT
Check BCM ground circuit. Refer to BCS-42, "Diagnosis Procedure".
Is the inspection result normal?
YES >> Replace BCM. Refer to BCS-96, "Removal and Installation".
NO >> Repair BCM ground circuit.
Low Tire Pressure Warning Lamp Flashes When
Ignition Switch Is Turned On
NOTE:
If low tire pressure warning lamp flashes as shown, the system is normal.
Flash Mode A
• This mode shows transmitt ...
ID Registration Cannot Be Completed
DIAGNOSTIC PROCEDURE
1.PERFORM ID REGISTRATION OF ALL TRANSMITTERS
Carry out ID registration of all transmitters. Refer to WT-6, "ID
Registration Procedu ...
Other materials: Operating tips
The sunload sensor, located on the top
center of the instrument panel, helps the
system maintain a constant temperature.
Do not put anything on or around this
sensor.
When the climate system is in automatic
operation and the engine coolant temperature
and outside air temperature are
low, the ...
Vehicle security system
The vehicle security system provides visual
and audible alarm signals if someone
opens the doors or trunk when the system
is armed. It is not, however, a motion detection
type system that activates when a vehicle
is moved or when a vibration occurs.
The system helps deter vehicle theft but
cannot p ...
Heater operation
Heating
This mode is used to direct heated air to
the foot outlets. Some air also flows from
the defrost outlets and the side vent
outlets.
1. Press thebutton to the off
position
for normal heating.
2. Press theair flow control
button.
3. Turn thefan speed control dial
to
the desired position.
...
Low tire pressure warning lamp
blinks
ID Registration cannot be completed