Nissan Altima (L32) 2007-2012 Service Manual: ID Registration cannot be completed
ID Registration Cannot Be Completed
DIAGNOSTIC PROCEDURE
1.PERFORM ID REGISTRATION OF ALL TRANSMITTERS
Carry out ID registration of all transmitters. Refer to WT-6, "ID
Registration Procedure".
Can ID registration of all transmitters be completed?
YES >> Inspection End.
NO >> GO TO WT-14, "Diagnosis Procedure".
Hazard Warning Lamps Flash When Ignition
Switch Is Turned On
DIAGNOSTIC PROCEDURE
1.CHECK BCM GROUND CIRCUIT
Check BCM ground circuit. Refer to BCS-42, "Diagnosis Procedure".
Is the i ...
NVH Troubleshooting Chart
Use chart below to help you find the cause of the symptom. If necessary,
repair or replace these parts.
×: Applicable ...
Other materials: MOD system limitations
WARNING
Listed below are the system limitations
for MOD. Failure to operate the vehicle
in accordance with these system limitations
could result in serious injury or
death.
Do not use the MOD system when
towing a trailer. The system may not
function properly.
Excessive noise (for example, audio ...
All-Wheel Drive (AWD) (if so equipped)
If any malfunction occurs in the AWD system
while the engine is running, messages
are displayed in the meter.
If the AWD error warning message is displayed,
there may be a malfunction in the
AWD system. Reduce vehicle speed and
have your vehicle checked. It is recommended
that you visit a NISSAN de ...
Steering Assist temporary
standby
Automatic standby due to driving
operation:
When the driver activates the turn signal,
the Steering Assist is temporarily placed in
a standby mode. (The Steering Assist restarts
automatically when the operating
conditions are met again.)
Automatic standby:
In the following cases, a warning message
i ...
Hazard warning lamps flash
Noise, vibration and harshness
(NVH) troubleshooting