Nissan Altima Owners Manual: Heated seats (if so equipped)

The front seats are warmed by built-in heaters.


The front seats are warmed by built-in heaters.

1. Start the engine.

2. Push the LO or HI position of the switch, as desired. The indicator light in the switch will illuminate.

The heater is controlled by a thermostat, automatically turning the heater on and off.

The indicator light will remain on as long as the switch is on.

3. When the seat is warmed or before you leave the vehicle, be sure to turn the switch off.

WARNING

Do not use or allow occupants to use the seat heater if you or the occupants cannot monitor elevated seat temperatures or have an inability to feel pain in body parts that contact the seat. Use of the seat heater by such people could result in serious injury.

CAUTION

● The battery could run down if the seat heater is operated while the engine is not running.

● Do not use the seat heater for extended periods or when no one is using the seat.

● Do not put anything on the seat which insulates heat, such as a blanket, cushion, seat cover, etc. Otherwise, the seat may become overheated.

● Do not place anything hard or heavy on the seat or pierce it with a pin or similar object. This may result in damage to the heater.

● Any liquid spilled on the heated seat should be removed immediately with a dry cloth.

● When cleaning the seat, never use gasoline, benzine, thinner, or any similar materials.

● If any malfunctions are found or the heated seat does not operate, turn the switch off and have the system checked by your NISSAN dealer.

    Horn
    To sound the horn, push near the horn icon on the steering wheel. WARNING Do not disassemble the horn. Doing so could affect proper operation of the supplemental front air bag system. Tampering ...

    Heated steering wheel (if so equipped)
    The heated steering wheel system is designed to operate only when the surface temperature of the steering wheel is below approximately 68°F (20°C). Push the heated steering wheel switch to w ...

    Other materials:

    P0043, P0044 HO2S3 heater
    Description SYSTEM DESCRIPTION The ECM performs ON/OFF control of the heated oxygen sensor 3 heater corresponding to the engine speed, amount of intake air and engine coolant temperature. OPERATION DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC C ...

    On-vehicle maintenance
    FRONT WHEEL HUB Inspection • Move wheel hub and bearing assembly in the axial direction by hand. Make sure there is no looseness of wheel bearing. Axial end play : 0.05 mm (0.002 in) or less • Rotate wheel hub and make sure that is no unusual noise or other irregular conditions. If ther ...

    Telescopic operation
    Pull the lock lever down 1 and adjust the steering wheel forward or backward 3 to the desired position. Push the lock lever up 1 firmly to lock the steering wheel in place. WARNING Do not adjust the steering wheel any closer to you than is necessary for proper steering operation and comfor ...