Nissan Altima Owners Manual: Heated steering wheel (if so equipped)

The heated steering wheel system is designed to


The heated steering wheel system is designed to operate only when the surface temperature of the steering wheel is below approximately 68°F (20°C).

Push the heated steering wheel switch to warm the steering wheel after the engine starts. The indicator light will come on.

If the surface temperature of the steering wheel is below 68°F (20°C), the system will heat the steering wheel to approximately 86°F (30°C), then turn off automatically.

Push the switch again to turn the heated steering wheel off manually. The indicator light will go off.

NOTE:

The heated steering wheel switch is equipped with a 30 minute timer. After the switch has been activated for 30 minutes, the system will automatically turn off. If the surface temperature of the steering wheel is above 68°F (20°C) when the switch is turned on, the system will not heat the steering wheel. This is not a malfunction.

    Heated seats (if so equipped)
    The front seats are warmed by built-in heaters. 1. Start the engine. 2. Push the LO or HI position of the switch, as desired. The indicator light in the switch will illuminate. The heater i ...

    Warning systems switch (if so equipped)
    The warning systems switch is used to temporarily turn off the warning systems (Lane Departure Warning (LDW) and Blind SpotWarning (BSW) systems) that are activated using the settings menu in th ...

    Other materials:

    Spark plug
    Removal and Installation 1. Ignition coil 2. Spark plug 3. Rocker cover REMOVAL 1. Remove the ignition coil. Refer to EM-35, "Removal and Installation". 2. Remove the spark plug with a suitable spark plug wrench. INSPECTION AFTER REMOVAL • Do not use a wire brush for clean ...

    Rear and rear-wide view monitor with moving object detection (MOD) (if so equipped)
    When the shift lever is shifted into the R (Reverse) position, the monitor display shows view to the rear of the vehicle. The system is designed as an aid to the driver in detecting large stationary objects to help avoid damaging the vehicle. The system will not detect small objects below th ...

    Anti-pinch system does not operate normally (driver side)
    Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement". Is the inspection result normal? YES >> GO TO 2 NO >> Repair or replace the mal ...