Nissan Altima (L32) 2007-2012 Service Manual: Intake sensor
Removal and Installation
REMOVAL
1. Remove the evaporator. Refer to VTL-20, "Removal and Installation".
2. Release the intake sensor clip and then remove the intake sensor.
CAUTION:
• Mark the mounting position of the intake sensor.
• Do not damage the evaporator core.
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation
REMOVAL
1. Remove the front RH speaker grille (1). Refer to AV-73,
"Removal and Installation".
2. Disconnect the connector.
3. Release the sunload sensor ta ...
Removal and Installation
COMPONENTS
1. Steering member
2. Heater and cooling unit
3. Blower unit
REMOVAL
1. Discharge the refrigerant from the A/C system. Refer to HA-24, "HFC-134a
(R- ...
Other materials: I-LI system operation
Lane Departure Warning (LDW) indicator
Intelligent Lane Intervention (I-LI) indicator
(if so equipped)
ProPILOT Assist switch (for vehicles with
ProPILOT Assist)
The I-LI system operates above approximately
37 mph (60 km/h). When the vehicle
approaches either the left or the right side
of th ...
How to use the vehicle information
display
The vehicle information display can be
changed using the ,
, and OK buttons located on the
steering
wheel.
- Use these buttons
to navigate the vehicle information
display.
OK - Change or select an item in the
vehicle information display.
- Returns to the previous
menu.
The OK, a ...
Additional maintenance items for
severe operating conditions
Additional maintenance items for severe
operating conditions should be performed
on vehicles that are driven under
especially demanding conditions. Additional
maintenance items should be performed
if you primarily operate your vehicle
under the following conditions:
Repeated short trips of less th ...
Sunload sensor
Heater & cooling unit assembly