Nissan Altima (L32) 2007-2012 Service Manual: IPDM E/R (Intelligent power distribution module engine room)
Diagnosis Procedure
1. CHECK FUSES AND FUSIBLE LINK
Check that the following IPDM E/R fuses or fusible link are not blown.
Is the fuse blown?
YES >> Replace the blown fuse or fusible link after repairing the affected
circuit.
NO >> GO TO 2
2. CHECK POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect IPDM E/R connectors.
3. Check voltage between IPDM E/R harness connector and
ground.
Is the measurement value normal?
YES >> GO TO 3
NO >> Repair harness or connector.
3. CHECK GROUND CIRCUIT
Check continuity between IPDM E/R harness connectors and
ground.
Does continuity exist?
YES >> Inspection End.
NO >> Repair harness or connector.
BCM
Diagnosis Procedure
1. CHECK FUSE AND FUSIBLE LINK
Check if the following BCM fuse or fusible link are blown.
Is the fuse or fusible link blown?
YES >> Replace the blown fuse or fus ...
Diagnosis Procedure
1.CHECK KEY SLOT POWER SUPPLY CIRCUI
1. Turn ignition switch OFF.
2. Disconnect key slot connector.
3. Check voltage between slot connector and ground.
Is the inspecti ...
Other materials: LDW system operation
For vehicles with the 7 inch (18 cm) display
The LDW system provides a lane departure
warning function when the vehicle is
driven at speeds of approximately 37 mph
(60 km/h) and above and the lane markings
are clear. When the vehicle approaches
either the left or the right side
of the traveling lan ...
Active noise cancellation/Active sound
enhancement (if so equipped)
Active noise cancellation
Front Microphone
This system uses microphones 1 located
inside the vehicle to detect engine booming
noise. The system then automatically generates
a noise cancelling sound through the
speakers and woofer (if so equipped) to reduce
engine booming noise.
NOTE:
To operate the ...
Heated steering wheel switch (if so equipped)
Push the heated steering wheel switch to
warm the steering wheel after the ignition
switch is placed in the ON position. The
indicator light will come on.
If the surface temperature of the steering
wheel is below 68ºF (20ºC), the system will
heat the steering wheel and cycle off and
on to mainta ...