Nissan Altima (L32) 2007-2012 Service Manual ≻ Security control system sedan without intelligent key ≻ Component diagnosis ≻ Key slot

Nissan Altima (L32) 2007-2012 Service Manual: Key slot

Diagnosis Procedure

1.CHECK KEY SLOT POWER SUPPLY CIRCUI

1. Turn ignition switch OFF.

2. Disconnect key slot connector.

3. Check voltage between slot connector and ground.

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace key slot power supply circuit.

2.CHECK KEY SLOT GROUND CIRCUIT

Check continuity between key slot connector and ground.

Is the inspection result normal? YES >> GO TO 3

NO >> Repair or replace key slot ground circuit.

3.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> Inspection End.

IPDM E/R (Intelligent power distribution module engine room)

Diagnosis Procedure 1. CHECK FUSES AND FUSIBLE LINK Check that the following IPDM E/R fuses or fusible link are not blown. Is the fuse blown? YES >> Replace the blown fuse or fusible ...

Key slot illumination

Description Blinks when keyfob insertion is required. Component Function Check 1.CHECK FUNCTION Check key slot illumination (“KEY SLOT ILLUMI”) Active Test mode. Is the inspection resul ...

Other materials:

Three-point type seat belt with retractor
WARNING Every person who drives or rides in this vehicle should use a seat belt at all times. Children should be in the rear seats and in an appropriate restraint. Do not ride in a moving vehicle when the seatback is reclined. This can be dangerous. The shoulder belt will not be against yo ...

Rear-facing child restraint installation using the seat belts
WARNING The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being properly secured. The restraint could tip over or be loose and cause injury to a child in a sudden stop o ...

Programming HomeLink
If you have any questions or are having difficulty programming your HomeLink buttons, refer to the HomeLink website at: www.homelink.com or call 1-800-355-3515. NOTE: Place the ignition switch in the ON position (without starting the engine) when programming HomeLink. It is also recommended that ane ...