Nissan Altima (L32) 2007-2012 Service Manual: Key slot
Diagnosis Procedure
1.CHECK KEY SLOT POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect key slot connector.
3. Check voltage between slot connector and ground.
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace key slot power supply circuit.
2.CHECK KEY SLOT GROUND CIRCUIT
Check continuity between key slot connector and ground.
Is the inspection result normal?
YES >> GO TO 3
NO >> Repair or replace key slot ground circuit.
3.CHECK INTERMITTENT INCIDENT
Refer to GI-42, "Intermittent Incident".
>> Inspection End.
BCM
Diagnosis Procedure
1. CHECK FUSE AND FUSIBLE LINK
Check if the following BCM fuse or fusible link are blown.
Is the fuse or fusible link blown?
YES >> Replace the blown fuse or fus ...
Description
Blinks when Intelligent Key insertion is required.
Component Function Check
1.CHECK FUNCTION
Check key slot illumination (“KEY SLOT ILLUMI”) Active Test mode.
Is the inspectio ...
Other materials: LED Daytime Running Lights (DRL)
system
The LED DRL automatically illuminate at
100% intensity when the engine is started
and the parking brake released. The LED
Daytime Running Lights (DRL) operate with
the headlight switch in any position. When
you turn the headlight switch to the
position for full illumination, the LED DRL
illuminate ...
Hood
Pull the hood lock release handle 1 located
below the driver's side instrument
panel; the hood springs up slightly.
To open the hood, push the lever 2 underneath
the front of the hood upwards
with your fingertips as illustrated and
raise the hood.
Remove the support rod from the clamp 3.
...
NISSAN Intelligent Key battery
discharge
If the battery of the NISSAN Intelligent Key
is discharged or environmental conditions
interfere with the Intelligent Key operation,
start the engine according to the following
procedure:
1. Place the shift lever in the P (Park)
position.
2. Firmly apply the foot brake.
3. Touch the ignition switc ...
POWER supply and ground circuit
Key slot illumination