Nissan Altima Owners Manual: Locking with key

Driver’s side


Driver’s side

Manual (if so equipped)

To lock a door, turn the key toward the front of the vehicle 1 . To unlock, turn the key toward the rear of the vehicle 2 .

Power (if so equipped)


Power (if so equipped)

The power door lock system allows you to lock or unlock all doors at the same time.

Turning the key toward the front 1 of the vehicle locks all doors.

Turning the key one time toward the rear 2 of the vehicle unlocks that door. From that position, returning the key to neutral 3 (where the key can only be removed and inserted) and turning it toward the rear again within 5 seconds unlocks all doors 4 .

Opening and closing windows (if so equipped)

The driver’s door key operation allows you to open and close windows equipped with automatic operation at the same time.

● To open the windows, turn the driver’s door key toward the rear of the vehicle for longer than 1 second after the door is unlocked.

● To close the windows, turn the driver’s door key toward the front of the vehicle for longer than 1 second after the door is locked.

Windows stop when the key cylinder is released.

    Doors
    When the doors are locked using one of the following methods, the doors can not be opened using the inside or outside door handles. The doors must be unlocked to open the doors. WARNING ● A ...

    Locking with inside lock knob
    Inside lock To lock the door without the key, move the inside lock knob to the lock position 1 , then close the door. To unlock the door without the key, move the inside lock knob to the unlo ...

    Other materials:

    B2609 steering status
    Description There are 2 switches in the electronic steering column lock (steering lock/unlock switch 1 and 2). BCM compares those two switches conditions to judge the present steering status. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2609 is displayed with DTC U1000, first perform the ...

    B2553 ignition relay
    Description BCM turns ON the following relays to ignition power supply to each ECU when the ignition switch is turned ON. • Ignition relay-1 (inside IPDM E/R) • Ignition relay-2 (inside fuse block) • Blower fan motor relay BCM checks any ignition relay ON request for consistency wit ...

    B2603 shift position status
    Description BCM confirms the shift position with the following 2 signals. • CVT selector lever • P/N position switch DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2603 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-36, "DTC Logic& ...