Nissan Altima Owners Manual: Making a call

To make a call, follow the procedure below:

1. Press the the control panel.  button on
the control panel.

The “Phone” screen will appear on the display.

2. Select one of the following options to make a call:
● “Phonebook”: Select the name from an entry stored in the vehicle phonebook.

● “Call Lists”: Select the name from the incoming, outgoing or missed.

● “Redial”: Dial the last outgoing call from the vehicle.

● “ manually ”: Input the phone number
manually using a keypad displayed on the screen. For information on how to use the touchscreen, see “How to use the touchscreen” in this section.

    Vehicle phonebook
    To access the vehicle phonebook: 1. Press the button on the control panel. 2. Select the “Phonebook” key. 3. Choose the desired entry from the displayed list. 4. The number of the entry wi ...

    Receiving a call
    When a call is placed to the connected phone, the display will change to phone mode. To accept the incoming call, either: ● Press the button on the steering wheel, or ● Touch the ...

    Other materials:

    B1209 – b1210 collision detection
    Description DTC B1209 - B1210 COLLISION DETECTION The air bag diagnosis sensor unit will set this DTC if it has detected a collision which has resulted in a frontal or side deployment of one or more air bags or pre-tensioners. If this DTC is detected after a SRS repair, the air bag diagnosis ...

    IPDM E/R (intelligent power distribution module engine room)
    Diagnosis Procedure 1. CHECK FUSES AND FUSIBLE LINK Check that the following IPDM E/R fuses or fusible link are not blown. Is the fuse blown? YES >> Replace the blown fuse or fusible link after repairing the affected circuit. NO >> GO TO 2 2. CHECK POWER SUPPLY CIRCUIT 1. Tu ...

    ABS branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the ABS actuator and electric unit (control unit) for damage, bend and loose connection (unit ...