Nissan Altima 2007-2012 Service Manual: On-vehicle repair

Preparation
Special Service Tools The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here. Commercial Service Tools ...

Windshield glass
Components 1. Windshield glass 2. Spacer 3. Mirror base 4. Adhesive 5. Roof panel 6. Front pillar outer panel 7. Cowl top center 8. Primer E. 7(0.28) F. 12 (0.47) G. 7.5 (0.30) H. 16 (0 ...

Other materials:

B26E1 No reception of engine status signal
Description BCM receives the engine status signal from ECM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B26E1 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-235, "DTC Logic". • If DTC B26E1 is displayed wi ...

Door outside molding
Removal and Installation 1. Front door outside molding 2. Front door Door Outside Molding Removal 1. Open the front door window fully. 2. Remove the side view mirror. Refer to MIR-19, "Removal and Installation". 3. Lift and twist front door molding from rear end, disconnect ...

P0448 evap canister vent control valve
Description The EVAP canister vent control valve is located on the EVAP canister and is used to seal the canister vent. This solenoid valve responds to signals from the ECM. When the ECM sends an ON signal, the coil in the solenoid valve is energized. A plunger will then move to seal the c ...