Nissan Altima 2007-2012 Service Manual: P1148 closed loop control
DTC Logic
DTC DETECTION LOGIC
NOTE: DTC P1148 is displayed with another DTC for A/F sensor 1.
Perform the trouble diagnosis for the corresponding DTC.
P0850 PNP Switch
Description
When the shift lever position is P or N (CVT), Neutral position (M/T),
park/neutral position (PNP) switch is ON.
ECM detects the position because the continuity of the line (the ON ...
P1217 engine over temperature
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC P1217 is displayed with DTC UXXXX, first perform the trouble diagnosis
for DTC UXXXX.
• If DTC P1217 is displayed with DTC P0607, first perfor ...
Other materials:
P0507 ISC System
Description
The ECM controls the engine idle speed to a specified level through the fine
adjustment of the air, which is let
into the intake manifold, by operating the electric throttle control actuator.
The operating of the throttle valve is
varied to allow for optimum control of the engine ...
B2013 ID discord, immu-strg
Description
BCM performs the ID verification with the steering lock unit and releases the
steering lock if both BCM and
steering lock unit ID are same. BCM starts the communication with the steering
lock unit when Intelligent Key
is carried into the passenger compartment and the push-button ...
BCM branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the BCM for damage, bend and loose
connection (unit side and
connector side).
Is the inspect ...