Nissan Altima Owners Manual: Park/turn signal lights
1. Disconnect the negative battery cable.
2. Remove the fasteners A ; carefully pull back the front fender protector.
3. Rotate the bulb B counterclockwise and pull out to remove.
Fog lights (if so equipped)
1. Disconnect the negative battery cable.
2. Remove the fasteners A ; carefully pull back
the front fender protector .
3. Rotate the bulb B counterclockwise and
pull out to remove.
Reverse st ...
Exterior and interior lights
*1 Always check with the Parts Department at a NISSAN dealer for the latest
parts information.
*2 See a NISSAN dealer for assistance.
1. Front map light
2. Headlamp assembly
3. Park/ Turn si ...
Other materials:
Bose speaker AMP
Diagnosis Procedure
1.CHECK FUSE
Check for blown fuses.
Are the fuses OK?
YES >> GO TO 2
NO >> Be sure to eliminate cause of malfunction before installing new fuse.
2.CHECK POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect BOSE speaker amp connector.
3. Chec ...
P1715 input speed sensor (primary
speed sensor)
Description
ECM receives primary speed sensor signal from TCM through CAN communication
line. ECM uses this signal
for engine control.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC P1715 is displayed with DTC UXXXX, first perform the trouble diagnosis
for DTC UXXXX.
• If DTC P1715 is ...
ABS branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the ABS actuator and electric unit
(control unit) for damage, bend
and loose connection (unit ...