Nissan Altima (L32) 2007-2012 Service Manual: Passenger side power window
alone does not operate
Diagnosis Procedure
1. CHECK POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH
Check power window and door lock/unlock switch RH.
Refer to PWC-200, "PASSENGER SIDE : Component Function Check".
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace the malfunctioning parts.
2. CHECK POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH SERIAL LINK CIRCUIT
Check power window and door lock/unlock switch RH serial link circuit.
Refer to PWC-218, "PASSENGER SIDE : Component Function Check".
Is the inspection result normal?
YES >> GO TO 3
NO >> Repair or replace the malfunctioning parts.
3. CHECK POWER WINDOW MOTOR RH CIRCUIT
Check power window motor RH circuit.
Refer to PWC-204, "PASSENGER SIDE : Component Function Check".
Is the inspection result normal?
YES >> Inspection End.
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Diagnosis Procedure
1. CHECK POWER WINDOW MOTOR LH
Check power window motor LH.
Refer to PWC-202, "DRIVER SIDE : Component Function Check".
Is the inspection result normal?
YES > ...
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-190, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special
Repair Requirement&qu ...
Other materials: Speedometer and odometer
This vehicle is equipped with a speedometer
and odometer. The speedometer is
located on the right side of the meter
cluster. The odometer is located within the
vehicle information display.
5 inch (13 cm) Type A (if so equipped)
Speedometer
The speedometer indicates vehicle speed.
7 inch (18 cm) Ty ...
Sonar limitations
WARNING
Listed below are the system limitations
for the sonar system. Failure to operate
the vehicle in accordance with these
system limitations could result in serious
injury or death.
The system is deactivated at speeds
above 6 mph (10 km/h). It is reactivated
at lower speeds.
Inclement weath ...
Radio
Place the ignition switch in the ACC or ON
position and press the PUSHbutton
to turn the radio on. If you listen to the radio
with the engine not running, the ignition
switch should be placed in the ACC
position.
Radio reception is affected by station signal
strength, distance from radio transmitte ...