Nissan Altima (L32) 2007-2012 Service Manual: Primary speed sensor
Exploded View
1. CVT assembly
2. O-ring
3. Primary speed sensor
Removal and Installation
Refer to the figure for removal and installation.
CAUTION:
• Do not reuse O-ring.
• Apply CVT fluid to O-ring.
• After installation is complete, check for CVT fluid leakage and CVT fluid
level. Refer to TM-416,
"Inspection".
Exploded View
1. Washer
2. Manual lever
3. PNP switch
4. CVT assembly
Removal and Installation
Refer to the figure for removal and installation.
NOTE:
• Align PNP switch position when ...
Exploded View
1. CVT assembly
2. Shims
3. O-ring
4. Secondary Speed Sensor
Removal and Installation
Refer to the figure for removal and installation.
CAUTION:
• Do not reuse O-ring.
...
Other materials: NISSAN Vehicle Immobilizer System
The NISSAN Vehicle Immobilizer System
will not allow the engine to start without
the use of a registered key.
If the engine fails to start using a registered
key (for example, when interference is
caused by another registered key, an automated
toll road device or automatic payment
device on the key ...
Programming HomeLink for Canadian
customers and gate openers
Canadian radio-frequency laws require
transmitter signals to "time-out" (or quit)
after several seconds of transmission -
which may not be long enough for
HomeLink to pick up the signal during
training. Similar to this Canadian law, some
U.S. gate operators are designed to "timeout"
in the same mann ...
Fuel-filler door
Opener operation
The fuel-filler door release is located below
the instrument panel. To open the fuel-filler
door, pull the release. To lock, close the fuel-filler
door securely.
Fuel-filler cap
WARNING
Gasoline is extremely flammable and
highly explosive under certain conditions.
You could be ...