Nissan Altima (L32) 2007-2012 Service Manual: Secondary speed sensor
Exploded View
1. CVT assembly
2. Shims
3. O-ring
4. Secondary Speed Sensor
Removal and Installation
Refer to the figure for removal and installation.
CAUTION:
• Do not reuse O-ring.
• Apply CVT fluid to O-ring.
• Insert the shims.
• After installation is complete, check for CVT fluid leakage and CVT fluid
level Refer to TM-416,
"Inspection".
Exploded View
1. CVT assembly
2. O-ring
3. Primary speed sensor
Removal and Installation
Refer to the figure for removal and installation.
CAUTION:
• Do not reuse O-ring.
• Apply CVT ...
Exploded View
1. Oil pump fitting bolt
2. O-ring
3. CVT assembly
Removal and Installation
Refer to the figure for removal and installation.
CAUTION:
• Do not reuse O-ring.
• Apply C ...
Other materials: Front manual seat adjustment
(if so equipped)
Your vehicle seats can be adjusted manually.
For additional information about adjusting
the seats, refer to the steps outlined
in this section.
WARNING
Before driving the vehicle, return the
seatback to an upright seating position
after manually releasing it. Also, make
sure the seat is locked in p ...
Heater operation
Heating
This mode is used to direct heated air to
the foot outlets. Some air also flows from
the defrost outlets and the side vent
outlets.
1. Press thebutton to the off
position
for normal heating.
2. Press theair flow control
button.
3. Turn thefan speed control dial
to
the desired position.
...
LED Daytime Running Lights (DRL)
system
The LED DRL automatically illuminate at
100% intensity when the engine is started
and the parking brake released. The LED
Daytime Running Lights (DRL) operate with
the headlight switch in any position. When
you turn the headlight switch to the
position for full illumination, the LED DRL
illuminate ...
Primary speed sensor
Oil pump fitting bolt