Nissan Altima 2007-2012 Service Manual: U1001 Can comm circuit

Description

CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring.

Each control unit transmits/receives data but selectively reads required data only.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON and wait at least 3 seconds.

2. Check 1st trip DTC.

Is 1st trip DTC detected? YES >> EC-150, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

Go to LAN-16, "Trouble Diagnosis Flow Chart".

    U0140 Can comm circuit
    Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellen ...

    P0011 IVT control
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0011 is displayed with DTC P0075, first perform the trouble diagnosis for EC-362, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PRECONDITIONI ...

    Other materials:

    BSW driving situations
    Another vehicle approaching from behind The Blind spot indicator light illuminates if a vehicle enters the detection zone from behind in an adjacent lane. However, if the overtaking vehicle is traveling much faster than your vehicle, the indicator light may not illuminate before the detec ...

    Headlamp
    Aiming Adjustment PREPARATION BEFORE ADJUSTING NOTE: • For details, refer to the regulations in your area. • Perform aiming adjustment if the vehicle front body has been repaired and/or the front combination lamp assembly has been replaced. Before performing aiming adjustment, check t ...

    P0127 IAT sensor
    Description The intake air temperature sensor is built-into mass air flow sensor (1). The sensor detects intake air temperature and transmits a signal to the ECM. The temperature sensing unit uses a thermistor which is sensitive to the change in temperature. Electrical resistance of the ther ...