Nissan Altima 2007-2012 Service Manual: U1001 Can comm circuit

Description

CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring.

Each control unit transmits/receives data but selectively reads required data only.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON and wait at least 3 seconds.

2. Check 1st trip DTC.

Is 1st trip DTC detected? YES >> EC-679, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

Go to LAN-16, "Trouble Diagnosis Flow Chart".

    U0140 Can comm circuit
    Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellen ...

    P0011 IVT Control
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0011 is displayed with DTC P0075, first perform the trouble diagnosis for EC-867, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PRECONDITION ...

    Other materials:

    P1553 battery current sensor
    Description The power generation voltage variable control enables fuel consumption to be decreased by reducing the engine load which is caused by the power generation of the generator. The battery current sensor is installed to the battery cable at the negative terminal. The sensor measures ...

    High-pressure flexible hose
    Removal and Installation for High-Pressure Flexible Hose QR25DE Removal 1. Discharge the refrigerant. Refer to HA-32, "HFC-134a (R-134a) Service Procedure". 2. Reposition the power steering reservoir out of the way without disconnecting the hose. 3. Reposition the engine coo ...

    P0603 ECM Power supply
    Description Battery voltage is supplied to the ECM even when the ignition switch is turned OFF for the ECM memory function of the DTC memory, the air-fuel ratio feedback compensation value memory, the idle air volume learning value memory, etc. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATI ...