Nissan Altima 2007-2012 Service Manual: Vehicle security indicator

Description

• Vehicle security indicator is built in combination meter.

• NVIS (Nissan Vehicle Immobilizer System-NATS) and vehicle security system conditions are indicated by blink or illumination of vehicle security indicator.

Component Function Check

1.CHECK FUNCTION

1. Perform “THEFT IND” in the “ACTIVE TEST” mode with CONSULT-III.

2. Check vehicle security indicator operation.

Is the inspection result normal? YES >> Inspection End.

NO >> Refer to SEC-514, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK COMBINATION METER

Check combination meter. Refer to MWI-4, "Work Flow".

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace the malfunctioning parts.

2.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> Inspection End.

    Warning lamp
    Description • Warning lamp is built in combination meter. • Remote keyless entry system malfunction is reported to the driver by the warning lamp illumination. Component Function Check 1. ...

    Other materials:

    Pre-inspection for diagnostic
    Basic Inspection The engine start function, door lock function, power distribution system and NATS-IVIS/NMS in the Intelligent Key system are closely related to each other regarding control. Narrow down the functional area in question by performing basic inspection to identify which function ...

    B2617 starter relay circuit
    Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2617 is display ...

    The fuel gauge pointer does not move to "f" when refueling
    Description The fuel gauge needle will not move to “F” position when refueling. Diagnosis Procedure 1.OBSERVE FUEL GAUGE Does it take a long time for the pointer to move to FULL position? YES or NO YES >> GO TO 2 NO >> GO TO 3 2.IDENTIFY FUELING CONDITION Was the vehicle fue ...