Nissan Altima (L32) 2007-2012 Service Manual: Warning lamp
Description
• Warning lamp is built in combination meter.
• Remote keyless entry system malfunction is reported to the driver by the
warning lamp illumination.
Component Function Check
1.CHECK FUNCTION
1. Perform “INDICATOR” in the “Active Test” mode with CONSULT-III.
2. Check warning lamp operation.
Is the inspection result normal?
YES >> Inspection End.
NO >> Refer to SEC-513, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK “COMBINATION METER.”
Check combination meter function. Refer to MWI-4, "Work Flow".
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace the malfunctioning parts.
2.CHECK INTERMITTENT INCIDENT
Refer to GI-42, "Intermittent Incident".
>> Inspection End.
Description
Headlamp lighting when theft warning system is in alarm phase.
Component Function Check
1.CHECK HEADLAMP OPERATION
Check if headlamps operate by lighting switch.
Does headlamp come ...
Description
• Vehicle security indicator is built in combination meter.
• NVIS (Nissan Vehicle Immobilizer System-NATS) and vehicle security system
conditions are indicated by
blink or illu ...
Other materials: Forward-facing child restraint
installation using LATCH
For additional information, see all Warnings
and Cautions in "Child safety" and
"Child restraints" before installing a
child restraint.
Do not use the lower anchors if the combined
weight of the child and the child restraint
exceeds 65 lbs. (29.5 kg). If the combined
weight of the child and the chi ...
Precautions on seat belt usage
If you are wearing your seat belt properly
adjusted and you are sitting upright and
well back in your seat with both feet on the
floor, your chances of being injured or killed
in a collision and/or the severity of injury
may be greatly reduced. NISSAN strongly
encourages you and all of your passeng ...
Resetting the drive computer
The drive computer is divided across three
screens:
Speed
Trip Distance & Time
Fuel Economy
1. Press the or
buttons until the
desired drive computer screen is
displayed.
2. Press the OK button to bring up the drive
computer Reset menu.
3. Use the or
to select the desired
option. Then press ...