Nissan Altima 2007-2012 Service Manual: CD Changer

Removal and Installation

REMOVAL

1. Remove the Cluster D lower finisher. Refer to IP-12, "Removal and Installation".

2. Put selector lever in the drive "D" position (CVT models only).

3. Put shift lever in neutral (M/T models only).

4. Using a suitable tool remove the CD changer finisher (1), then disconnect the power socket, AUX jack connectors and remove the CD changer finisher (1).

5. Remove the CD changer screws (A), pull out the unit, then disconnect the CD changer connector and remove the CD changer (1).

6. Remove the CD changer bracket screws (A).

• CD changer brackets (1) • CD changer (2)

INSTALLATION

Installation is in the reverse order of removal.

    Bose speaker AMP
    Removal and Installation - Coupe REMOVAL 1. Disconnect the negative battery terminal. 2. Remove the trunk floor carpet and spare tire cover. Refer to INT-23, "Removal and Installation&quo ...

    Front tweeter
    Removal and Installation REMOVAL 1. Remove the front pillar finisher. Refer to INT-15, "Removal and Installation" (coupe) and INT-36, "Removal and Installation" (sedan). 2. ...

    Other materials:

    Fuel level sensor signal circuit
    Description The fuel level sensor unit and fuel pump detects the approximate fuel level in the fuel tank and transmits the fuel level signal to the combination meter. Component Function Check 1.COMBINATION METER INPUT SIGNAL 1. Select “METER/M&A” on CONSULT-III. 2. Using “FUEL M ...

    On-vehicle repair
    POWER SOCKET Removal and Installation FRONT POWER SOCKET Removal 1. Remove the instrument panel storage bin or CD changer finisher (if equipped). Refer to IP-17, "Exploded View". 2. Remove the inner socket (1) from the ring (2) while pressing the hooks (B) on the ring (2) out fr ...

    P2118 Throttle control motor
    Description The throttle control motor is operated by the ECM and it opens and closes the throttle valve. The current opening angle of the throttle valve is detected by the throttle position sensor. The throttle position sensor it provides feedback to the ECM, when opens/closes the throttle ...