Nissan Altima 2007-2012 Service Manual: Cowl top

Removal and Installation

1. Cowl top seal

2. Cowl top side trim covers

3. Cowl top foam blocks

4. Cowl top

A Clips

REMOVAL

1. Remove both the RH and LH wiper arms. Refer to WW-116, "FRONT WIPER ARMS : Removal and Installation".

2. Remove the cowl top side trim covers.

3. Remove the cowl top foam blocks.

4. Remove the cowl top clips and remove the cowl top.

INSTALLATION

Installation is in the reverse order of removal.

    Front grille
    Removal and Installation 1. Front grille 2. Bumper fascia FRONT GRILLE Removal 1. Remove the front grille clips. 2. Release the grille tabs from the front bumper fascia, then remove the ...

    Fender protector
    Removal and Installation 1. Fender protector 2. Fender protector side cover A. J-clips B. Clips C. Center mudguard screw a. Sheet metal nut REMOVAL 1. Remove the engine under cover. Refer ...

    Other materials:

    B2110 PNP/clutch interlock switch
    Description IPDM E/R confirms the shift position with the following signals. • Park/neutral position (PNP) switch (CVT models) • Clutch inter lock switch (M/T models) • Shift position signal from BCM (CAN) DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2110 is displayed with DTC U1 ...

    On board diagnostic (OBD) system
    Diagnosis Description INTRODUCTION The ECM has an on board diagnostic system, which detects malfunctions related to engine sensors or actuators. The ECM also records various emission-related diagnostic information including: The above information can be checked using procedures listed in ...

    P0172 fuel injection system function
    DTC Logic DTC DETECTION LOGIC With the Air/Fuel Mixture Ratio Self-Learning Control, the actual mixture ratio can be brought closely to the theoretical mixture ratio based on the mixture ratio feedback signal from the A/F sensors 1. The ECM calculates the necessary compensation to correct t ...