Nissan Altima 2007-2012 Service Manual: Front grille
Removal and Installation
1. Front grille
2. Bumper fascia
FRONT GRILLE
Removal
1. Remove the front grille clips.
2. Release the grille tabs from the front bumper fascia, then remove the front grille.
Installation
Installation is in the reverse order of removal.
Rear bumper
Removal and Installation
1. Rear bumper supports
2. Rear bumper reinforcement
3. Energy absorbing foam
4. Splash shield LH
5. Rear bumper fascia
6. Splash shield RH
REMOVAL
1. Remove the L ...
Cowl top
Removal and Installation
1. Cowl top seal
2. Cowl top side trim covers
3. Cowl top foam blocks
4. Cowl top
A Clips
REMOVAL
1. Remove both the RH and LH wiper arms. Refer to WW-116, "FRON ...
Other materials:
IPDM-E branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the IPDM E/R for damage, bend and loose
connection (unit side
and connector side).
Is the in ...
Power generation voltage variable
control system operation inspection
Inspection Procedure
CAUTION:
When performing this inspection, always use a charged battery that has completed
the battery inspection.
(When the charging rate of the battery is low, the response speed of the voltage
change will
become slow. This can cause an incorrect inspection.)
1.CHECK ...
P0102, P0103 MAF sensor
Description
The mass air flow sensor (1) is placed in the stream of intake air. It
measures the intake flow rate by measuring a part of the entire
intake flow. The mass air flow sensor controls the temperature of the
hot wire to a certain amount. The heat generated by the hot wire is
reduced a ...