Nissan Altima 2007-2012 Service Manual: On-vehicle repair
- Front bumper
- Rear bumper
- Front grille
- Cowl top
- Fender protector
- Mudguard
- Side guard molding
- Door outside molding
- Drip molding
- Roof side molding
- License lamp finisher
- Rear spoiler
On-vehicle maintenance
SQUEAK AND RATTLE TROUBLE DIAGNOSES
Work Flow
CUSTOMER INTERVIEW
Interview the customer, if possible, to determine the conditions that exist
when the noise occurs. Use the Diagnostic
Workshee ...
Front bumper
Removal and Installation
1. Front bumper supports
2. Front bumper reinforcement
3. Energy absorbing foam
4. Tow cover
5. Front grille
6. Engine under cover
7. Fog lamp finisher (if equipped)
...
Other materials:
P1740 lock-up select solenoid
valve
Description
• Lock-up select solenoid valve controls lock-up clutch pressure or forward
clutch pressure (reverse brake
pressure).
• When controlling lock-up clutch, the valve is turned OFF. When controlling
forward clutch, it is turned ON.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIR ...
P0710 cvt fluid temperature sensor
Description
The CVT fluid temperature sensor detects the CVT fluid temperature and sends
a signal to the TCM.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If “DTC CONFIRMATION PROCEDURE” has been previously performed, ...
Camera on signal circuit (coupe)
Description
When the selector lever is placed in the R position, the rear view camera
control unit sends a camera ON signal
to the rear view camera.
Diagnosis Procedure
1.CHECK CAMERA ON SIGNAL CIRCUIT CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect rear view camera control unit con ...