Nissan Altima (L32) 2007-2012 Service Manual ≻ Exterior sedan ≻ On-vehicle repair ≻ Drip molding

Nissan Altima (L32) 2007-2012 Service Manual: Drip molding

Removal and Installation

REMOVAL

1. Using a trim stick or equivalent, disconnect the drip mouldings starting at the front, working rearward.

2. Remove the drip moldings.

INSTALLATION

Installation is in the reverse order of removal.

• Insert drip moldings onto vehicle starting at the rear, working forward.

Door outside molding

Removal and Installation 1. Front door outside molding 2. Rear door outside molding Front Door Outside Molding Removal 1. Open the front door window fully. 2. Remove the side view mirror. ...

Roof side molding

Removal and Installation 1. Body side outer panel 2. Windshield 2. Windshield REMOVAL 1. Lift and twist the roof side molding up from the rear edge. 2. Disconnect the roof side molding ...

Other materials:

System temporarily unavailable
For vehicles with the 7 inch (18 cm) display Condition A When the radar sensor picks up interference from another radar source, making it impossible to detect a vehicle ahead, the I-FCW system is automatically turned off. The AEB with Pedestrian Detection system warning light (yellow) will illumin ...

Booster seats
For additional information on installing a booster seat in your vehicle, follow the instructions outlined in this section. Precautions on booster seats WARNING If a booster seat and seat belt are not used properly, the risk of a child being injured or killed in a sudden stop or collision greatly inc ...

Automatic operation
Cooling and/or dehumidified heating (AUTO) This mode may be used all year round as the system automatically works to keep a constant temperature. Air flow distribution, air intake control, and fan speed are also controlled automatically. 1. Press the AUTO button on. 2. Turn the temperature control ...