Nissan Altima 2007-2012 Service Manual: Function diagnosis
- Engine control system
- Multiport fuel injection system
- Electric ignition system
- Air conditioning cut control
- Automatic speed control device (ASCD)
- Can communication
- Cooling fan control
- Electronic controlled engine mount
- Evaporative emission system
- Intake valve timing control
- Variable induction air system
- On board diagnostic (OBD) System
Mixture ratio self-learning value
clear
Description
This describes show to erase the mixture ratio self-learning value. For the
actual procedure, follow the instructions
in “Diagnosis Procedure”.
Special Repair Requirement
1.START ...
Engine control system
System Diagram
System Description
ECM performs various controls such as fuel injection control and ignition
timing control.
Component Parts Location
1. Power valve actuator 1
2. Intake va ...
Other materials:
Power supply routing circuit
Wiring Diagram — Battery Power Supply —
Wiring Diagram — Accessory Power Supply —
Wiring Diagram — Ignition Power Supply —
Fuse
• If fuse is blown, be sure to eliminate cause of malfunction before
installing new fuse.
• Use fuse of spe ...
Heated seats (if so equipped)
The front seats are warmed by built-in heaters.
1. Start the engine.
2. Push the LO or HI position of the switch, as
desired. The indicator light in the switch will
illuminate.
The heater is controlled by a thermostat,
automatically turning the heater on and off.
The indicator light w ...
B210E starter relay
Description
Located in IPDM E/R, it runs the starter motor. The starter relay is turned
ON by the BCM when the ignition
switch is in START position. IPDM E/R transmits the starter relay ON signal to
BCM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B210E is displaye ...
