Nissan Altima (L32) 2007-2012 Service Manual: License lamp finisher
Removal and Installation
1. License lamp finisher
REMOVAL
1. Remove the trunk lid finisher (if equipped). Refer to INT-22, "Exploded
View".
2. Remove the license lamp finisher nuts.
3. Remove license lamp finisher by pulling toward the rear, then disconnect the
trunk request switch connector.
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation
1. Body side outer panel
2. Windshield
2. Windshield
REMOVAL
1. Lift and twist the roof side molding up from the rear edge.
2. Disconnect the roof side molding ...
Removal and Installation
1. Rear spoiler assembly
2. High mounted stop lamp harness
3. Gasket
A. Nuts
Removal
1. Remove trunk lid finisher (if equipped). Refer to INT-23, "Removal and
...
Other materials: Hood
Pull the hood lock release handle 1 located
below the driver's side instrument
panel; the hood springs up slightly.
To open the hood, push the lever 2 underneath
the front of the hood upwards
with your fingertips as illustrated and
raise the hood.
Remove the support rod from the clamp 3.
...
Rear-facing child restraint installation
using the seat belts
WARNING
The three-point seat belt with Automatic
Locking Retractor (ALR) must be
used when installing a child restraint.
Failure to use the ALR mode will result
in the child restraint not being properly
secured. The restraint could tip over or
be loose and cause injury to a child in a
sudden stop o ...
Air bags, seat belts and child restraints
Top tether strap anchor
Rear seat belts with pretensioner(s) for
outboard seating
Roof-mounted curtain side-impact and
rollover supplemental air bag
Front seat-mounted side-impact
supplemental air bag
Head restraints/headrests
Front seat belt with pretensioner(s) and
shoulder height adju ...
Roof side molding
Rear spoiler