Nissan Altima (L32) 2007-2012 Service Manual: Steering switch
Removal and Installation
REMOVAL
1. Remove the driver airbag module. Refer to SR-5, "Removal and
Installation".
2. Remove the steering wheel switch assembly screws (A), then
remove the steering wheel switches (1).
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation
REMOVAL
1. Lower the headliner at the rear. Refer to INT-20, "Removal and
Installation" (coupe) and INT-42,
"Removal and Installation" (sedan).
2. ...
Removal and Installation - Coupe
REMOVAL
1. Remove the rear pillar finisher RH. Refer to INT-15, "Removal and
Installation".
2. Detach the antenna amp harness clip (B), disconnect th ...
Other materials: Warning/Indicator lights (red)
For additional information on warnings
and indicators, see "Vehicle information
display - 5 inch (13 cm) Type A" or
"Vehicle information display - 7 inch (18cm)
Type B".
or
Brake warning
light
This light functions for both the parking
brake and the foot brake systems.
Parking brake indicator (if s ...
MOD system operation
The MOD system will turn on automatically
under the following conditions:
When the shift lever is in the R (Reverse)
position.
When the CAMERA button is pressed to
activate the camera view on the display.
When vehicle speed decreases below approximately
6 mph (10 km/h) and the
camera screen ...
Changing engine oil and oil filter
For additional information on engine oil
and oil filter change, refer to the instructions
outlined in this section.
Vehicle set-up
1. Park the vehicle on a level surface and
apply the parking brake.
2. Run the engine until it reaches operating
temperature.
3. Turn the engine off and wait for 15 mi ...