Nissan Altima 2007-2012 Service Manual: A-BAG branch line circuit

Diagnosis Procedure

1.CHECK AIR BAG DIAGNOSIS SENSOR UNIT

Check the air bag diagnosis sensor unit. Refer to SRC-3, "Work Flow".

Is the inspection result normal? YES >> Replace the main harness.

NO >> Replace parts whose air bag system has a malfunction.

    ECM branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and co ...

    BCM branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

    Other materials:

    Off-road recovery
    If the right side or left side wheels unintentionally leave the road surface, maintain control of the vehicle by following the procedure below. Please note that this procedure is only a general guide. The vehicle must be driven as appropriate based on the conditions of the vehicle, road and t ...

    B210D starter relay
    Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B210D is displaye ...

    Control valve
    Exploded View COMPONENT PARTS LOCATION 1. Transaxle assembly 2. Control valve 3. Bracket 4. O-ring 5. Oil strainer assembly 6. Magnet 7. Oil pan bolt 8. Oil pan 9. Oil pan gasket 10. Lock nut 11. Washer 12. Manual plate 13. Collar 14. Lip seal 15. Snap ring A. CVT unit connector ...