Nissan Altima 2007-2012 Service Manual: Power distribution system
- Basic inspection
- Function diagnosis
- Component diagnosis
- U1000 can comm circuit
- U1010 control unit (CAN)
- B2553 ignition relay
- B260A ignition relay
- B2611 ACC relay
- B2614 ACC relay circuit
- B2615 blower relay circuit
- B2616 ignition relay circuit
- B2618 BCM
- B261A push-button ignition switch
- Power supply and ground circuit
- Push-button ignition switch position indicator
- ECU diagnosis
- Symptom diagnosis
- Precaution
- On-vehicle repair
On-vehicle repair
IPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM) Removal and Installation REMOVAL 1. Disconnect the battery negative terminal. 2. Remove the IPDM E/R cover (1) while pressing the p ...Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW Work Flow OVERALL SEQUENCE DETAILED FLOW 1. GET INFORMATION FOR SYMPTOM Get the detailed information from the customer about the symptom (the condition and the e ...Other materials:
Main line between DLC and ABS circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose
connection (connector side
and harness side).
- Harness co ...
Installing top tether strap
First, secure the child restraint with the LATCH
lower anchors (rear outboard seat positions only)
or the seat belt, as applicable.
1. Flip up the anchor cover 1 from the anchor
point which is located directly behind the
child seat.
2. Position the top tether strap over the top of
the hea ...
Clearing the programmed information
The following procedure clears the programmed
information from both buttons. Individual buttons
cannot be cleared. However, individual buttons
can be reprogrammed. See “Reprogramming a
single HomeLink® button” in this section.
To clear all programming:
1. Press and hold the two outer Ho ...