Nissan Altima 2007-2012 Service Manual: Power window control system lh&rh front anti-pinch-coupe
- Basic inspection
- Function diagnosis
- Component diagnosis
- Power supply and ground circuit
- Power window motor
- Encoder
- Door switch
- Door key cylinder switch
- Power window serial link
- Power window lock switch
- ECU diagnosis
- Precaution
- Symptom diagnosis
- None of the power windows can be operated using any switch
- Driver side power window alone does not operate
- Passenger side power window alone does not operate
- Anti-pinch system does not operate normally (driver side)
- Anti-pinch system does not operate normally (passenger side)
- Auto operation does not operate but manual operates normally (driver side)
- Auto operation does not operate but manual operates normally (passenger side)
- Power window retained power operation does not operate properly
- Does not operate by key cylinder switch
- Keyless power window down does not operate
- Power window lock switch does not function
- On-vehicle maintenance
- On-vehicle repair
On-vehicle repair
POWER WINDOW MAIN SWITCH
Removal and Installation
REMOVAL
1. Remove the power window main switch finisher (2). Refer to
INT-34, "Removal and Installation".
2. Power window main swit ...
Basic inspection
...
Other materials:
Service data and specifications
(SDS)
General Specification
CAUTION:
• Use only Genuine NISSAN CVT Fluid NS-2. Do not mix with other fluid.
• Using CVT fluid other than Genuine NISSAN CVT Fluid NS-2 will deteriorate in
driveability and CVT durability, and may damage
the CVT, which is not covered by the warranty.
*1: Refe ...
Lan system circuit
Description
SYMPTOM: Mode door motor, intake door motor and/or air mix door motor does
not operate normally.
Diagnosis Procedure
DIAGNOSIS PROCEDURE FOR LAN CIRCUIT
1.CHECK POWER SUPPLY FOR DOOR MOTORS
1. Press ignition switch ON.
2. Check voltage between front air control connector M37 ...
Shift position indicator
System Diagram
System Description
The TCM receives CVT indicator signals from the park/neutral position (PNP)
switch. The TCM then sends
CVT position indicator signals to the combination meter via CAN communication
lines. The combination meter
indicates the received shift position.
Compon ...