Nissan Altima 2007-2012 Service Manual: Lan system can system (type 7)
COMPONENT DIAGNOSIS
- Main line between dlc and abs circuit
- ECM branch line circuit
- A-BAG branch line circuit
- BCM branch line circuit
- DLC branch line circuit
- M&A branch line circuit
- ABS branch line circuit
- TCM branch line circuit
- IPDM-E branch line circuit
- Can communication circuit
Can communication circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CONNECTOR INSPECTION
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Disconnect all the unit connect ...
Main line between dlc and abs circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and co ...
Other materials:
B2108 steering lock relay
Description
The steering lock relay ON signal is transmitted to IPDM E/R by BCM via CAN
communication.
IPDM E/R turns the steering lock relay ON and transmits the release of the
steering to BCM.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2108 is displayed with DTC U1000, first perf ...
P0222, P0223 TP sensor
Description
Electric throttle control actuator consists of throttle control motor,
throttle position sensor, etc. The throttle position sensor responds to
the throttle valve movement.
The throttle position sensor has two sensors. These sensors are a
kind of potentiometer which transform the t ...
On-vehicle maintenance
ENGINE COOLANT
System Inspection
WARNING:
• Never remove the radiator cap when the engine is hot. Serious burns could
occur from high pressure
coolant escaping from the radiator.
• Wrap a thick cloth around the cap. Slowly push down and turn it a quarter turn
to allow built-up pressur ...