Nissan Altima 2007-2012 Service Manual: Seat belt system

Removal and installation
EPS CONTROL UNIT Removal and Installation REMOVAL 1. Remove audio/navi unit. Refer to AV-72, "Removal and Installation" or AV-437, "Removal and Installation" (with navi). ...

Precaution
Supplemental Restraint System (SRS) "AIR B AG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used al ...

Other materials:

B26e1 no reception of engine status signal
Description BCM receives the engine status signal from ECM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B26E1 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-36, "DTC Logic". • If DTC B26E1 is displayed wit ...

B2617 starter relay circuit
Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2617 is display ...

Rear regulator
Exploded View 1. Rear door 2. Door glass run 3. Door glass 4. Inside seal 5. Partition sash 6. Door rear glass seal 7. Door rear glass 8. Regulator assembly 9. Window motor 10. Water shield Disassembly 1. Remove the power window motor screws (A). 2. Remove power window motor from re ...