Nissan Altima 2007-2012 Service Manual: Horn

Condenser
Removal and Installation - Coupe REMOVAL 1. Remove the rear seat cushion and the rear seatback. Refer to SE-25, "Removal and Installation". 2. Remove the rear kicking plate, rear whe ...

Precaution
Supplemental Restraint System (SRS) AIR BA G and SEAT BELT PRE-TENSIONER The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat be ...

Other materials:

P0101 maf sensor
Description The mass air flow sensor (1) is placed in the stream of intake air. It measures the intake flow rate by measuring a part of the entire intake flow. The mass air flow sensor controls the temperature of the hot wire to a certain amount. The heat generated by the hot wire is reduced a ...

B2617 Starter relay circuit
Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2617 is display ...

B2557 vehicle speed
Description BCM receives the 2 vehicle speed signals via CAN communication. One signal is transmitted by the “unified meter”. Another signal is transmitted by “ABS actuator and electric unit (control unit)”. BCM compares both signals to detect the vehicle speed. DTC Logic DTC DETEC ...