Nissan Altima 2007-2012 Service Manual: Power window control system lh&rh front anti-pinch-sedan
- Basic inspection
- Function diagnosis
- Component diagnosis
- Power supply and ground circuit
- Power window motor
- Encoder
- Door key cylinder switch
- Power window serial link
- Power window lock switch
- ECU diagnosis
- Precaution
- Symptom diagnosis
- None of the power windows can be operated using any switch
- Driver side power window alone does not operate
- Front passenger side power window alone does not operate
- Rear lh side power window alone does not operate
- Rear rh side power window alone does not operate
- Anti-pinch system does not operate normally (driver side)
- Anti-pinch system does not operate normally (passenger side)
- Auto operation does not operate but manual operates normally (driver side)
- Auto operation does not operate but manual operates normally (passenger side)
- Power window retained power operation does not operate properly
- Does not operate by key cylinder switch
- Keyless power window down does not operate
- Power window lock switch does not function
- On-vehicle maintenance
- On-vehicle repair
On-vehicle repair
POWER WINDOW MAIN SWITCH
Removal and Installation
REMOVAL
1. Remove the power window main switch finisher (2). Refer to
INT-12, "Removal and Installation".
2. Power window main sw ...
Basic inspection
...
Other materials:
P1805 brake switch
Description
Brake switch signal is applied to the ECM through the stop lamp switch when
the brake pedal is depressed.
This signal is used mainly to decrease the engine speed when the vehicle is
driving.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATI ...
Steering wheel
Removal and Installation
REMOVAL
NOTE:
When reconnecting spiral cable, fix cable with a tape so that fixing case and
rotating part keep aligned. This
will omit neutral position alignment procedure during spiral cable installation.
1. Set vehicle to the straight-ahead position.
2. Remove ...
B2109 steering lock relay
Description
The steering lock relay ON signal is transmitted to IPDM E/R by BCM via CAN
communication.
IPDM E/R turns the steering lock relay ON and transmits the release of the
steering to BCM.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2109 is displayed with DTC U1000, first perf ...