Nissan Altima 2007-2012 Service Manual: Transaxle & transmission cvt: RE0F10A
- Basic inspection
- Function diagnosis
- CVT system
- Mechanical system
- Hydraulic control system
- Control system
- Lock-up and select control system
- Shift mechanism
- Shift lock system
- On board diagnostic (OBD) System
- Diagnosis system (TCM)
- Component diagnosis
- U1000 can comm circuit
- U1010 control unit (CAN)
- P0703 stop lamp switch
- P0705 park/neutral position switch
- P0710 CVT fluid temperature sensor
- P0715 input speed sensor (pri speed sensor)
- P0720 vehicle speed sensor cvt (secondary speed sensor)
- P0725 engine speed signal
- P0730 belt damage
- P0740 torque converter clutch solenoid valve
- P0744 A/T TCC S/V function (lock -up)
- P0745 line pressure solenoid valve
- P0746 pressure control solenoid a performance (line pressure solenoid valve)
- P0776 pressure control solenoid B performance (sec pressure solenoid valve)
- P0778 pressure control solenoid B electrical (sec pressure solenoid valve)
- P0826 manual mode switch
- P0840 transmission fluid pressure sensor A (sec pressure sensor)
- P0841 pressure sensor function
- P0868 secondary pressure down
- P1701 transmission control module (power supply)
- P1705 throttle position sensor
- P1722 estm vehicle speed signal
- P1723 cvt speed sensor function
- P1726 electric throttle control system
- P1740 lock-up select solenoid valve
- P1745 line pressure control
- P1777 step motor
- P1778 step motor - function
- Shift position indicator circuit
- Shift lock system
- Ecu diagnosis
- Symptom diagnosis
- Precaution
- Preparation
- On-vehicle maintenance
- On-vehicle repair
- Transmission control module
- Control device
- Control cable
- Differential side oil seal
- Air breather hose
- Park/neutral position (PNP) switch
- Primary speed sensor
- Secondary speed sensor
- Oil pump fitting bolt
- Control valve
- Removal and installation
- Disassembly and assembly
- Service data and specifications (SDS)
Service data and specifications
(SDS)
General Specification
CAUTION:
• Use only Genuine NISSAN CVT Fluid NS-2. Do not mix with other fluid.
• Using CVT fluid other than Genuine NISSAN CVT Fluid NS-2 will deteriorate in
drive ...
Basic inspection
...
Other materials:
Both side headlamps do not switch
to high beam
Description
The headlamps (both sides) do not switch to high beam when the lighting
switch is in the HI or PASS setting.
Diagnosis Procedure
1.COMBINATION SWITCH INSPECTION
Check the combination switch. Refer to BCS-10, "System Description".
Is the combination switch normal?
YE ...
Main line between dlc and abs circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose
connection (connector side
and harness side).
- Harness co ...
ABS branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the ABS actuator and electric unit
(control unit) for damage, bend
and loose connection (unit ...