Nissan Altima 2007-2012 Service Manual: Exterior sedan
License lamp finisher
Removal and Installation
1. License lamp finisher
REMOVAL
1. Remove the trunk lid finisher (if equipped). Refer to INT-23, "Removal and
Installation".
2. Remove the license lamp fi ...
Precaution
Precaution for Supplemental Restraint System
(SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER ...
Other materials:
P0603 ECM Power supply
Description
Battery voltage is supplied to the ECM even when the ignition switch
is turned OFF for the ECM memory function of the DTC memory, the
air-fuel ratio feedback compensation value memory, the idle air volume
learning value memory, etc.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATI ...
Additional service when replacing control unit
Description
When replacing ECM, this procedure must be performed.
Special Repair Requirement
1.PERFORM INITIALIZATION OF NATS SYSTEM AND REGISTRATION OF ALL NATS IGNITION
KEY IDS
Refer to SEC-15, "ECM RE-COMMUNICATING FUNCTION : Special Repair Requirement"
(Coupe) or SEC-
214, &qu ...
CD changer
Diagnosis Procedure
1.CHECK FUSE
Check that the following fuses of the CD changer are not blown.
Are the fuses OK?
YES >> GO TO 2
NO >> Be sure to eliminate cause of malfunction before installing new fuse.
2.CHECK POWER SUPPLY CIRCUIT
Check voltage between CD changer harness con ...