Nissan Altima 2007-2012 Service Manual: Lan system can system (type 2)
COMPONENT DIAGNOSIS
- Main line between DLC And ABS Circuit
- ECM branch line circuit
- A-BAG branch line circuit
- AV branch line circuit
- BCM branch line circuit
- DLC Branch line circuit
- M&A branch line circuit
- ABS branch line circuit
- IPDM-E branch line circuit
- Can communication circuit
Can communication circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CONNECTOR INSPECTION
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Disconnect all the unit connect ...
Main line between DLC And ABS Circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and co ...
Other materials:
On-vehicle maintenance
ENGINE COOLANT
System Inspection
WARNING:
• Never remove the radiator cap when the engine is hot. Serious burns could
occur from high pressure
coolant escaping from the radiator.
• Wrap a thick cloth around the cap. Slowly push down and turn it a quarter turn
to allow built-up pressur ...
Steering switch (sedan)
Description
When one of the steering wheel audio control switches is pushed, the
resistance in steering switch circuit
changes depending on which button is pushed.
Diagnosis Procedure
WITH BLUETOOTH
1.CHECK HARNESS
1. Turn ignition switch OFF.
2. Disconnect Bluetooth control unit connect ...
Programming HomeLink® for Canadian customers and gate openers
Canadian radio-frequency laws require transmitter
signals to “time-out” (or quit) after several
seconds of transmission – which may not be long
enough for HomeLink® to pick up the signal
during training. Similar to this Canadian law,
some U.S. gate operators are designed to “timeout” ...