Nissan Altima 2007-2012 Service Manual: Lan system can system (type 10)
COMPONENT DIAGNOSIS
- Main line between DLC and ABS circuit
- ECM branch line circuit
- A-BAG branch line circuit
- AV branch line circuit
- BCM branch line circuit
- DLC branch line circuit
- M&A branch line circuit
- STRG branch line circuit
- ABS branch line circuit
- IPDM-E branch line circuit
- Can communication circuit
Can communication circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CONNECTOR INSPECTION
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Disconnect all the unit connect ...
Main line between DLC and ABS circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and co ...
Other materials:
B2602 shift position
Description
BCM confirms the shift position with the following 2 signals.
• CVT selector lever
• Speed signal from meter
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2602 is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to
SEC-433, "DTC ...
B261A push-button ignition switch
Description
BCM transmits the change in the power supply position with the push-button
ignition switch to IPDM E/R via
the CAN communication line. IPDM E/R transmits the power supply position status
via CAN communication
line to BCM.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCED ...
P0506 ISC System
Description
The ECM controls the engine idle speed to a specified level through the fine
adjustment of the air, which is let
into the intake manifold, by operating the electric throttle control actuator.
The operating of the throttle valve is
varied to allow for optimum control of the engine ...