Nissan Altima 2007-2012 Service Manual: Audio, visual & navigation system bose audio with navigation
- Basic inspection
- Function diagnosis
- Multi AV system (coupe)
- Multi av system (sedan)
- Navigation system (coupe)
- Navigation system (sedan)
- Rear view monitor system (coupe)
- Rear view monitor system (sedan)
- Audio system (coupe)
- Audio system (sedan)
- Hands free phone system (coupe)
- Hands free phone system (sedan)
- Diagnosis system (AV control unit)
- Component diagnosis
- U1000 Can comm circuit
- U1010 control unit (CAN)
- U1200 AV control unit
- U1201 AV control unit
- U1204 GPS comm
- U1205 GPS ROM
- U1206 GPS RAM
- U1207 GPS RTC
- U1208 DVD-ROM comm
- U1209 DVD-ROM read
- U120A DVD-ROM disc
- U120C DVD-ROM mecha detect
- U120D DVD-ROM drive mecha
- U1210 DVD-ROM seek
- U1212 DVD-ROM data forward
- U1213 DVD-ROM data
- U1214 DVD-ROM timeout
- U1215 DVD-ROM load
- U1216 AV control unit
- U1217 AV control unit
- U1220 AV control unit
- U1244 GPS antenna
- U124C CD changer
- Power supply and ground circuit (coupe)
- Power supply and ground circuit (sedan)
- Door speaker (coupe)
- Front door speaker (sedan)
- Front tweeter (coupe)
- Tweeter (sedan)
- Center speaker
- Rear tweeter (coupe)
- Rear door speaker (sedan)
- Subwoofer (coupe)
- Subwoofer (sedan)
- AMP On signal circuit
- Steering switch
- Microphone signal circuit
- Camera image signal circuit (rear view camera to camera control unit)(coupe)
- Camera image signal circuit (rear view camera to camera control unit)(sedan)
- Camera on signal circuit (coupe)
- Camera on signal circuit (sedan)
- Camera image signal circuit (camera control unit to av control unit)
- Reverse signal circuit
- ECU diagnosis
- AV Control unit (coupe)
- AV control unit (sedan)
- Bose speaker AMP
- Rear view camera control unit
- CD changer
- Symptom diagnosis
- Precaution
- Reparation
- On-vehicle repair
Bluetooth control unit
Removal and Installation - Coupe
REMOVAL
1. Disconnect the battery negative terminal.
2. Remove the trunk floor carpet and spare tire cover. Refer to INT-22,
"Exploded View".
3. R ...
Basic inspection
...
Other materials:
P0500 VSS
Description
The vehicle speed signal is sent to the combination meter from the “ABS
actuator and electric unit (control
unit)” via the CAN communication line. The combination meter then sends a signal
to the ECM via the CAN
communication line.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• I ...
Anti-pinch system does not operate
normally (driver side)
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-21, "POWER WINDOW MAIN SWITCH : Special Repair Requirement".
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace the malfunctioning parts.
2. C ...
U0415 vehicle speed sig
Description
U0415 is displayed if any unusual condition is present in the reception
status of the vehicle speed signal from
the ABS actuator and electric unit (control unit).
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1. DTC CONFIRMATION
1. Erase the DTC.
2. Turn igniti ...