Nissan Altima 2007-2012 Service Manual: Glass & window system
- Symptom diagnosis
- Precaution
- Preparation
- On-vehicle repair
- Windshield glass
- Rear window glass
- Front door glass
- Front regulator
- Rear door glass
- Rear regulator
- Side window glass
- Disassembly and assembly
Push button ignition switch
Removal and Installation
REMOVAL
1. Remove the cluster lid A assembly. Refer to IP-12, "Removal and
Installation".
2. Release the pawls (A) and remove the push-button ignition
switch ...
Symptom diagnosis
SQUEAK AND RATTLE TROUBLE DIAGNOSES
Work Flow
CUSTOMER INTERVIEW
Interview the customer if possible, to determine the conditions that exist
when the noise occurs. Use the Diagnostic
Worksheet ...
Other materials:
IPDM E/R (Intelligent power distribution
module engine room)
Reference Value
VALUES ON THE DIAGNOSIS TOOL
TERMINAL LAYOUT
PHYSICAL VALUES
Wiring Diagram — Coupe
Fail Safe
CAN COMMUNICATION CONTROL
When CAN communication with ECM and BCM is impossible, IPDM E/R performs
fail-safe control. After CAN
communication ...
BCM branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the BCM for damage, bend and loose
connection (unit side and
connector side).
Is the inspec ...
Power steering fluid
Inspection
FLUID LEVEL
• Check fluid level with engine stopped.
• Make sure that fluid level is between MIN and MAX.
• Fluid levels at HOT (A) and COLD (B) are different. Do not confuse
them.
CAUTION:
• The fluid level should not exceed the MAX line. Excessive
flu ...