Nissan Altima 2007-2012 Service Manual: Meter, warning lamp & indicator
- Basic inspection
- Function diagnosis
- Component diagnosis
- DTC U1000 can communication
- DTC B2205 Vehicle speed circuit
- Power supply and ground circuit
- Fuel level sensor signal circuit
- Oil pressure switch signal circuit
- Parking brake switch signal circuit
- Washer level switch signal circuit
- Ambient sensor signal circuit
- Compass
- ECU diagnosis
- Combination meter
- BCM (Body control module)
- IPDM E/R (Intelligent power distribution module engine room)
- Symptom diagnosis
- The fuel gauge pointer does not move
- The fuel gauge pointer does not move to "f" when refueling
- The oil pressure warning lamp does not turn on
- The oil pressure warning lamp does not turn off
- The parking brake release warning continues displaying, or does not display
- The low washer fluid warning continues displaying, or does not display
- The door open warning continues displaying, or does not display
- The ambient temperature display is incorrect
- Normal operating condition
- Precaution
- On-vehicle repair
- Disassembly and assembly
Service data and specifications (SDS)
Battery
...
Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW
Work Flow
DETAILED FLOW
1.CONFIRM SYMPTOM
Confirm symptom or customer complaint.
>> GO TO 2
2.CHECK SELF-DIAGNOSIS OPERATION OF COMBINATION METER
Perform ...
Other materials:
Vehicle recovery (freeing a stuck vehicle)
Pulling a stuck vehicle
WARNING
To avoid vehicle damage, serious personal
injury or death when recovering a stuck
vehicle:
● Contact a professional towing service
to recover the vehicle if you have any
questions regarding the recovery
procedure.
● Do not use the vehicle tie-down ...
P1226 TP Sensor
Description
Electric throttle control actuator consists of throttle control motor,
throttle position sensor, etc. The throttle position sensor responds to
the throttle valve movement.
The throttle position sensor has two sensors. These sensors are a
kind of potentiometer which transform the t ...
DLC branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the data link connector for damage,
bend and loose connection
(connector side and harness side) ...